Samsung SGH-A727ZKAATT - Manual (Page 92)

89
5. To create a new connection, press the Options soft key, select New, and
press the Select soft key or the key.
- or -
6. To edit the existing AT&T MMS, highlight this entry, press the Options soft
key, select Edit, and press the Select soft key or the key.
7. The following parameters are displayed:
• Set Name: enter a profile name.
• Access Name: edit the access point name.
• Auth Type: select the type of authentication used for this WAP connection:
None, Normal, or Secure.
• User ID: enter the User ID required to connect to the network.
• Password: enter the user password required to connect to the network.
• Protocol: set the connection protocol used by the WAP browser: WAP, HTTP, or
Other.
• Home URL: enter the URL address of the page to be used as your homepage.
• Gateway address: (wap1.x only) enter the gateway address of the proxy server.
• Proxy address: (wap2.x and AT&T MMS) set the proxy server address and port.
• Linger Time (Sec.): set a time period (in seconds) after which the network is
disconnected if there has been no new data traffic in that time.
• Advanced Settings: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic Class.
- Static IP: specify if you want to manually enter an IP address. If you want the IP
address to be automatically assigned by the server, remove the check mark.
- Local phone IP: enter the IP address obtained from the network operator, if you
checked the Static IP option.
- Static DNS: specify if you want to manually enter the Domain Name Server
(DNS) address. If you want the address to be automatically assigned by the
server, remove the check mark.
- Server 1/Server 2: enter the Domain Name Server (DNS) addresses.
- Traffic Class: select the traffic class.
Note: The WAP settings may vary depending on the service provider.
Configuring your Phone’s USB Connection
Your phone can connect to a PC via the USB cable (sold separately). The phone can
be configured to open launch a default application when an active USB connection is
detected.
1. Use the USB adapter cable to connect the handset to the target PC. When
an active connection has been established, a USB icon ( ) appears on