Samsung SPA400BX-XAA - Manual (Page 10)

Power Cable Remote Control/ 1 Batteries Cleaning Cloth
Sold separately
D-Sub Cable
LED Indications
●:Light is On ◐:Light is Blinking ○:Light is Off
STAND
BY
LAMP TEMP Information
● ○ ○
If you press the POWER button on the remote control or projector, the screen
appears within 30 seconds.
● ● ○ The projector is in normal operating condition.
● ◐ ○
This state appears when the projector is preparing an operation after the POWER button
on the projector or the remote control has been pressed.
○ ◐ ○
The POWER button is pressed to turn off the projector, and the cooling system is in
operation to cool off the inside of the projector. (Lasts for about 1 minute and 30
seconds)
◐ ○ ◐
Refer to Action 1 below if the cooling fan inside the projector is not in normal operation
condition.
○ ◐ ◐
Refer to Action 2 below if the lamp cover protecting the lamp unit is not closed
properly.
○ ○ ◐
Power is turned off automatically when temperature inside of the projector goes beyond
the control limit. Refer to Action 3.
● ◐ ◐ A problem has occurred when operating the DDP IC in the product. Refer to Action 4.
◐ ◐ ◐ A problem has occurred with the operation of the lamp. Refer to Action 5.
● ◐ ● The lifetime of the lamp has expired. Refer to Action 6.
◐ ◐ ○ The memory in the product is not operating normally. Contact a service center .
◐ ◐ ● The power for the product is not operating normally. Contact a service center .
◐ ● ◐
A problem has occurred when operating the color wheel in the product. Refer to Action
4.
Clearing Indicator Problems