Samsung SEC-R350WRAMTR - Manual (Page 24)

21
Note: End Calls Before relaunching the VoiceSignal voice recognition
software — When you use Voice Dialing to make a call, you must end
that call before you can use other Voice Commands. See “Voice SVC”
on page 58 for more information.
Use the Call command to dial any number stored in your Contacts
list by saying the name of the contact (Name Dialing). You can
also use Call to dial any telephone number, even numbers not
stored in your contact list, by speaking the individual digits in the
number (Digit Dialing).
Voice Dialing Tips:
• Wait for the beep before speaking.
• Speak clearly at a normal volume, as if you were talking to someone
on the phone.
• When saying a name, say the first name then the last name.
Dialing a Name
To dial a name, do the following:
1. In Standby mode, press and hold .
“Say a command” appears in the display and is
pronounced through the earpiece.
2. Say, “Call”.
You are prompted to “Say the name or number”.
3. Speak clearly and say the name of a person in your
Contacts list, first name followed by last name.
If the name is recognized, Voice Dial repeats the name and
dials the number.
If Voice Dial is not sure which name you said, it displays a
choice list of up to three names and prompts you with “Did
you say?” followed by the first name on the list.
4. Say “Yes” to confirm the name or “No” to hear the next
name, or use the keypad to select the correct name from
the list. (See “Choice Lists” on page 59, for more
information.)
• Press Repeat to say the name again.
• Press to exit VoiceSignal without dialing.
If the recognized name has multiple numbers stored for it
(that is, Mobile, Work, Home, and so on), Voice Dial
displays the possible choices and prompts you with “Which
number?”
5. Say one of the following number types:
• “Home”
• “Work”
• “Mobile”
Voice Dial dials the specified number.
Dialing a Number
To dial a number using Voice Dial, do the following:
1. In Standby mode, press and hold .