APC AR8184 - Manual (Page 2)

Data Cable Partitions—Installation 2
Installing Data Cable Partitions
Use the procedure in this section to install all of the Data Cable Partitions. You can install Data Cable
Partitions on a NetShelter Enclosure or a PDU.
1. Squeeze the two sides of the Pass-through Data Cable Partition to insert the fastening tabs into a
set of square holes.
2. Determine the width that will be required for data cable routing, then install the Data Cable
Partition at the front of the roof with a solid side in the same manner as step 1.
Note: Use a Data Cable Partition with a solid side at the front of the enclosure to
ensure a finished appearance.
n
s12
99
b
ns
13
00
b