Samsung LN40A500T1FXZA - Manual (Page 12)

English - 10
Connecting a VCR
Video Connection
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the
instructions on pages 6~7). Skip step 1 if you have not yet connected to an antenna or a cable system.
1. Unplug the cable or
antenna from the back
of the TV.
2. Connect the cable or
antenna to the ANT IN
terminal on the back of
the VCR.
3. Connect an RF Cable
between the ANT OUT
terminal on the VCR
and the ANT IN terminal
on the TV.
4. Connect a Video
Cable between the
VIDEO OUT jack on
the VCR and the AV IN
[Y/VIDEO] jack on the
TV.
5. Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN [R-AUDIO-L] jacks
on the TV.
If you have a “mono”
(non-stereo) VCR,
use a Y-connector
(not supplied) to
connect to the
right and left audio
input jacks of the
TV. Alternatively,
connect the cable to
the “R” jack. If your
VCR is stereo, you
must connect two
cables.
➣
ANT IN
Follow the instructions in “Viewing a VCR or Camcorder Tape” to view your VCR tape.
Each VCR has a different back panel configuration.
When connecting a VCR, match the color of the connection terminal to the cable.
When connecting to AV IN, the color of the AV IN [Y/VIDEO] jack (Green) does not
match the color of the video cable (Yellow).
➣
➣
➣
VCR Rear Panel
TV Rear Panel
RF Cable (Not supplied) 
Video Cable (Not supplied) 4
Audio Cable (Not supplied) 
BN68-01796A-00Eng.indd 10 2008-07-29 �� 4:43:07