Selecting the video signal-source, Storing channels automatically, Storing channels manually – Samsung LNS2352WX-XAA User Manual
Page 15
English-13
Storing Channels Manually
You can store up to 100 channels, including those received via cable networks.
1.
Press the MENU button to display the menu.
Press the
or
button to select “Channel”, then press the ENTER
button.
2.
Press the
or
button to select “Add/Delete”.
Press the ENTER
button.
3.
Repeatedly pressing the ENTER
button will alternate between add channel and delete channel.
4.
Press the CH
or CH
button to switch to the appropriate channel, then repeat above.
5.
Press the EXIT button to exit.
You can view any channel (including an erased channel) by using the number buttons on the remote control.
Use the number buttons to directly select the channel that will be added or erased.
Press the ADD/DEL button on the remote control.
Storing Channels Automatically
The TV automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
1.
To select the signal source, follow the “Selecting the Video Signal-source” instructions
number 1 to 3 on page 13.
2.
Press the
or
button to select “Auto Program”. Press the ENTER
button.
3.
Press the ENTER
button. The channel search will start and end automatically.
Press the
ENTER
button at any time to interrupt the memorization process and return to the “Channel” menu.
4.
After all the available channels are stored, the “Channel” menu reappears.
5.
Press the EXIT button to exit.
Press the AUTO PROG. button on the remote control.
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the TV (i.e. an antenna or a cable system).
1.
Press the MENU button to display the menu.
Press the
or
button to select “Channel”, then press the ENTER
button.
2.
Press the ENTER
button to select “Air/Cable”.
3.
Press the
or
button to select the video signal source, then press the ENTER
button.
4.
Press the EXIT button to exit.
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in your particular area.
At this point, the signal source has been selected. Proceed to “Storing Channels Automatically”.
BN68-00998B-00Eng.qxd 3/7/06 2:55 AM Page 13