Samsung NP270E5E-K03US - Manual (Page 70)

68 69
Chapter 3.
Using the computer
5
When the system reboots, press the corresponding key(s) by
following the onscreen instructions.
6
When the computer restarts automatically and the Samsung
logo screen appears, press the F2 key repeatedly.
7
Select the Security > TPM Configuration > Change TPM
Status item and set the item to Enable and Activate.
Aptio Setup Utility
TPM Configuration
TPM Support
Change TPM Status
Security Chip State
Security
[Enabled]
[
No Change ]
Disabled and Deactivated
No Change
Clear
Enable and Activate
Disable and Deactivate
8
Press the F10 key to save the changes.
9
When the system reboots, press the corresponding key(s) by
following the onscreen instructions.
10
Press the F10 key to save the changes. The computer
automatically restarts. Initialization of the TPM chip has been
completed. Now, install the TPM program and register the
TPM program.
Installing the TPM program
You can install the TPM program as follows.
This program is only provided for models with Recovery and
the TPM function.
1
Turn the computer on and immediately press the F4 key
several times.
2
After a moment, the Recovery program runs.
3
Click System Software.
4
When a pop-up window appears to ask you to reboot
the system, click Yes. The system starts to reboot. After a
moment, the SW Update program automatically runs.
5
Connect to the network.
6
Select TPM Host SW and click Install.
Using the TPM Security Device
(Optional)