Samsung DVDV3800V-XAA - Manual (Page 29)

55
Press the SEARCH button to display the search screen in the stop
mode. When a program is recorded, the starting point is given an
Index mark for easy location. However, the VHS Index Search
System (VISS) cannot recognize index marks made by old VCRs. If
the VCR has trouble finding a mark, it is probably because the
cassette was recorded on a VCR without VISS. If you want to index
two programs in a row, set your VCR to stop, then start recording
each program. Pause has no effect on index marks.
1 Go to 0:00:00 stop
Use this feature when you want to search for the 0:00:00 counter
position on a cassette. Press the CLEAR button at the point on the
tape where you want to set the counter to 0:00:00. While a
cassette is stopped, press the ENTER button. The VCR will rewind
or fast forward, searching for the 0:00:00 counter position, and then
automatically stop at that position.
2 End search
Use this feature when you want to search for a blank position to
record a program on a cassette. While a cassette is stopped, press
ENTER button. The VCR will fast forward, searching for a blank
position, and then automatically stop at that position. If the VCR
reaches the end of the tape during end search, the tape will be
ejected.
3 Scan and play
Use scan and play when you don’t know exactly where a program
is located on a cassette tape.
- Forward Intro Scan
Highlight “Forward Intro Scan”, then press the ENTER button.
- Reverse Intro Scan
Highlight “Reverse Intro Scan”, then press the ENTER button.
Variable Search System
Forward
Reverse
54
If you want your videotapes to play automatically when you insert
them, turn on Auto Play.
NOTE: Only tapes that are missing the Record Safety Tab will
play automatically when inserted.
1 Open the “MENU”
With the DVD in Stop or Play mode, press the MENU button.
2 Select “VCR”
Using the Up/Down buttons, move the selection bar to
“VCR” then press ENTER to select.
3 Select “Tape Length”
Press the RIGHT button to select the video cassette length.
This information is usually printed on the tape box. The menu
cycles through: T120, T160 or T180. Once the type of cassette is
set, the VCR can display the amount of time remaining on the tape
when you press the INFO. button.
4 Select “Auto Play”
Move the selection bar to “Auto Play,” then press right to select
from the following options:
• On - The VCR will automatically begin playing a video tape
when it is inserted, as long as the safety tab of the cassette has
been removed.
• Off - Auto play is disabled.
5 Select “Auto Repeat”
Move the selection bar to “ Auto Repeat” sets the VCR to
play a tape repeatedly [unless a tape control is activated (stop, fast
forward or rewind)].
Auto Play
S-VHS Playback
The DVD-VCR allows you to playback high quality S-VHS tapes.
1 Insert a S-VHS Tape
Insert an S-VHS tape into the VCR deck.
2 Start Playback
Press Play/Pause on the remote control to begin playback of the S-VHS tape.
n
n
n Off
On
On
Off
T120
T160
T180
00222A DVD-V3800/XAA-Eng4 7/28/03 3:41 PM Page 54