Aligning the heights of the refrigerator doors, Installing the water dispenser line, Connecting to the water supply line – Samsung RS27FDBTNSR-AA User Manual

Page 20

Advertising
background image

20_

setting up

ALIGNING THE HEIGHTS OF THE
REFRIGERATOR DOORS

If the Fridge door is lower than the Freezer door,
adjust the door height by turning the door height
adjustment bolt at the bottom of the Fridge door.

Height difference

• Turning it counter clockwise increases the

height of the door and turning it clockwise
decreases the height of the door.

• Loosen the screw ( 

1 ), turn the adjusting bolt

2 ) with a spanner to align the door height to

the Freezer door and then fix it by fastening the
screw ( 

1 ).

(1) Screw

(2) Adjusting bolt

• After adjusting the height, be sure to install the

protective rubber inserts as shown in the figure
to protect your feet from injury.

If you increase the height of the Fridge
door by too much, the switch may be
damaged or the door may not close
properly.

CAUTION

INSTALLING THE WATER
DISPENSER LINE

A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.

Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼” compression nut.

Connecting to the water supply line

1. First, shut off the main water

supply.

2. Locate the nearest cold water drinking line and

install the pipe clamp and shut off valve.

Pipe clamp

Cold water line

Shut off valve

DA68-02935A-04.indb 20

2014. 5. 14. �� 9:38

Advertising
This manual is related to the following products: