Samsung SGH-D806ZKAGEN - Manual (Page 119)

Section 10: WAP 119
Changing the WAP Profiles
You can set up server profiles for the WAP browser.
1. In Idle mode, press the Menu soft key to access Menu mode.
2. Select Settings. Highlight Connection Settings and press the Select soft
key or the
key.
3. Select the profile you want.
For each profile, the following options are available:
ⅷ Profile Name: enter a name that you wish to assign to the HTTP proxy server.
ⅷ Home URL: set the address of your startup homepage. When the default
homepage displays, you can delete it using the
key and enter your own
choice.
ⅷ Proxy: place a check in the box to use the proxy server.
ⅷ IP Address: enter the IP address of the proxy server.
ⅷ Port: enter a port number or use default setting.
ⅷ DNS
מ DNS1 : enter the primary DNS (Domain Name System) address.
מ DNS2 : enter the secondary DNS address.
ⅷ Bearer: select the bearer to be used for each type of network address accessed:
GPRS or GSM. The remaining options depend on the Bearer setting.
When the bearer is set to GPRS:
ⅷ APN: enter the access point name used for the address of the GPRS network
gateway.
ⅷ Login ID: enter the User ID required to connect to the GPRS network.
ⅷ Password: enter the password required to connect to the GPRS network.
When the bearer is set to GSM:
ⅷ Dial Number: enter the PPP server phone number
ⅷ Login ID: enter the PPP server login ID.
ⅷ Password: enter the PPP server password.
ⅷ Data Call Type: select a data call type: Analog or ISDN.
Note: The WAP settings may vary depending on the service provider.
OK /