ABL electronic PIC Microcontrollers PIC16 - Manual (Page 161)

SPI module is available with a number of PICmicros. mikroC provides a library
(driver) for working with the external CAN modules (such as MCP2515 or
MCP2510) via SPI.
In mikroC, each routine of CAN library has its CANSPI counterpart with identical
syntax. For more information on the Controller Area Network, consult the CAN
Library. Note that the effective communication speed depends on the SPI, and is
certainly slower than the “real” CAN.
Note: CANSPI functions are supported by any PIC MCU that has SPI interface on
PORTC. Also, CS pin of MCP2510 or MCP2515 must be connected to RC0.
Example of HW connection is given at the end of the chapter.
Note: Be sure to check CAN constants necessary for using some of the functions.
See page 145.
CANSPISetOperationMode
CANSPIGetOperationMode
CANSPIInitialize
CANSPISetBaudRate
CANSPISetMask
CANSPISetFilter
CANSPIRead
CANSPIWrite
Following routines are for the internal use by compiler only:
RegsToCANSPIID
CANSPIIDToRegs
MikroElektronika: Development tools - Books - Compilers
153
page
mikroC - C Compiler for Microchip PIC microcontrollers
mikroC
making it simple...
CANSPI Library
Library Routines