Samsung UN110S9VFXZA User Manual

Quick start guide, Welcome to your new smart tv, Lm r

Advertising
background image

BN68-06329B-00

QUICK START

GUIDE

Welcome to your new Smart TV!

The following instructions cover assembling, connecting, and setting up your new TV. Make sure

you have the accessories listed below.

Included in this box

Step 1

Installing the
Wall Mount

Step 5

Power on and
start the initial
setup

Step 4

Using the
Samsung
Smart Control

Step 3

Connect
devices

Step 2

Connect
Audio Devices

Step 1

Installing the Wall Mount

Installation Precautions

Use the provided accessories and parts to install the wall mount.

Install the product onto a flat wall surface only.

Avoid the following areas to ensure the best product performance and prevent malfunctions:

- Areas that are susceptible to vibration and impact: The TV might come loose from the mount

and be damaged.

- Next to fire sprinklers: Heat generated by the TV could activate the sprinkler.
- Near high-voltage cables: Electronic interference from the high-voltage cables may disrupt

the screen display.

- Near a heating appliance: The product may overheat and malfunction.
- Check the stability of the wall surface.
- If the wall is too weak, reinforce it before installing the mount.

Do not remove a section of the wall and install the mount there.

Plug all the cables into the correct ports and connectors before installing the wall mount.

If attempting to install the product onto a non-concrete wall, consult an installation specialist

first.

Once installed, the gap between the wall surface and the TV should be at least 44 mm.

For the types of walls the TV can be mounted on, check the model of your TV and then the

corresponding installation guide on the back of the product.

Wall Mount Accessories

Use only the provided accessories and parts to install the wall mount.

(6)

Mount Holder

(22)

M8 X 40

(16)

M4 X 8

Wall mount bracket

Left: x1, Right: x1,

Center: x1

Aluminum bar

(x2)

Length

Adjustment Bars

Ø25 : x4

(24)

M5 X 65

(24)

Anchor

User Manual

] Check the type of the wall before installing.

Installation requirements for each wall type

Can only be mounted on a concrete or interior wall of sufficient thickness. Refer to the diagrams

below.

Min. 10mm

MDF, PW

Concrete

Mixed Concrete

Wall (excluding

drywall thickness)

Art Wall

Min. 30 mm

Min.

25 mm

NOTE

MDF = Medium Density

Fiberboard
PW = Plywood

Min. 50 mm

Min. 10 mm

Min. 30 mm

Min. 10 mm

Art Wall

MDF or PW

MDF or PW

MDF or PW

Min.

50 mm

Min.

25 mm

With MDF

or plywood

reinforcement

MDF or PW

(Excluding

drywall thickness)

Installation is not possible on a drywall or on a wall with no internal reinforcement.

0~24 mm

Art Wall

Drywall

No internal

reinforcement

Cannot install directly on drywall.

MDF, PW, or Concrete

1

1-1

1-2

TV

wall

1-1

1-2

TV

wall

Object

Object

31mm

1-1.

If the wall is not flat, a gap may form

after the installation is completed and

this may result in a poor finish.

1-2.

The TV cannot be mounted on the wall

if there is an object between the TV and

the wall that is 31 mm or thicker.

Check the wall’s type, thickness, and flatness.

2

L

M

R

Check the L, M, and R markings on the front sides of the wall mount brackets.

3

Attach the length adjustment bar to each of the three wall mount brackets and tighten it using
the screws .

4

Place the assembly against the wall you wish to mount it on, and then mark the anchor insertion

points on the wall.

5

E

] Installation on drywall with studs.

15mm

D

Insert the anchors and screws where marked.

Requirements

Verify the location of the studs first and use wall screws.

Minimum Stud Size: 51x102mm or 2x4 in (Drill 3mm holes before inserting wall screws).

Drill the holes along the central axis of the stud.

Inserting the screws without pre-drilling the holes can split the stud.

] The manufacturer will not be held liable for any issue arising from failure

to comply with the instructions and requirements contained in this
installation guide.

6

Remove the screws that hold the wall mount brackets in place.

7

Aluminum bar

Tighten the aluminum bar on the back of the TV using the screws as shown.

] Make sure to insert the pieces into the correct holes.

One Connect Accessories:

One connect, one connect cable

Also included: User manual, regulatory guide, IR extender,

component adapter, RCA adapter x 2, power cord,

Ferrite core, Cleaning Cloth

Samsung Smart Control &

Batteries (AAA x 2)

RETURN

EXIT

GUIDE

CH.LIST

SMART HUB

KEYPAD SOURCE

VOL

CH

VOICE

3D

CC

P.SIZE

MTS

MENU

INFO

SEARCH

MIC

TV

UN110S9VF_QSG_ENG-US.indd 2

2014-05-30 11:29:10

Advertising