NewAir ACP-1400E - Manual (Page 10)

10
Timer Timer Timer
Timer
For all of the following TIMER programming, proceed firstly with these
standard
steps:
• Press the
button briefly, the 2 digits on the control panel will show 00.
• Press the button again to program the timer for ON – when the unit is
OFF or program the timer for OFF – when the unit is RUNNING. The time
will be increased by hour from 00, 01, 02…..24, thence go back from 24, 23,
22…..00 by each press of the button.
• Press the button briefly to adjust the time as 00 to cancel the timer
function.
Sleep Sleep Sleep
Sleep
mode mode mode
mode
The sleep mode function adjusts the set temperature of the unit to the
thermal needs of the body falling asleep as follows:
• Default fan speed: Low
• Press the button to operate the sleep mode. Press the button again
in order to cancel the sleep mode. The set temperature will increase 2℉
after 1 hour and a further 2℉ after 2 hours.
• No FAN ONLY / DEHUMIDIFICATION mode under SLEEP mode operation.
Dehumidification Dehumidification Dehumidification
Dehumidification
If the unit will be used mainly as a dehumidifier just let the warm air return in
the room. Continuous drainage (see separate chapter) is then necessary
and more efficient. Only low fan speed under dehumidifying.
Heat Heat Heat
Heat
(optional (optional (optional
(optional
function) function) function)
function)
The unit features a heat pump that can heat a room on cooler days. With the
mode switch select ‘heat’ with the temperature in 68℉ as default. You can
set the desired temperature and the unit will heat until this temperature is
reached.
Do not place the unit near anything that could catch fire or be scorched.
Do not obstruct the air outlet.