Samsung HCR4245WX-XAA - Manual (Page 2)

English-2
Connecting VHF and UHF Antennas
1
Place the wires from the twin leads under the
screws on the 300-75 ohm adaptor (not supplied).
Use a screwdriver to tighten the screws.
2
Plug the adaptor into the “ANT 1 IN (Air)” terminal
on the rear panel.
If you do not have a cable system, you will need to connect an antenna to your TV.
Antennas with 300-ohm Flat Twin Leads
If your antenna looks like this: it has 300-ohm flat twin leads.
1
Plug the antenna lead into the “ANT 1 IN (Air)”
terminal on the rear panel.
Antennas with 75-ohm Round Leads
If your antenna looks like this: it is an antenna with 75-ohm round leads.
1
Connect both antenna leads to the combiner.
2 Plug the combiner into the “ANT 1 IN (Air)” terminal
on the rear panel.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two
antenna signals before connecting the antennas to the TV. This procedure requires an optional
combiner-adaptor (available at most electronics shops).
BP68-00383B_Quick Guide 2005/01/28 10:20 AM Page 2