Samsung LS57BPHNBG-ZA - Manual (Page 8)

English - 8
Installing Batteries in the Remote Control
1 Remove the cover on the rear of the remote control by
pressing the symbol ( ) downwards and then pulling firmly to
remove it.
2 Install two AAA size batteries.
➢  Make sure to match the “ +” and “–” ends of the
batteries with the diagram inside the compartment.
 Do not mix battery types, i.e. alkaline and manganese.
3 Replace the cover by aligning it with the base of the remote
control and pressing it back into place.
➢ Remove the batteries and store them in a cool and dry
place if you won’t be using the remote control for a long
time. The remote control can be used up to about 23 feet
from the PDP Display. (Assuming typical PDP Display
usage, the batteries last for about one year.)
➢ If the remote control doesn’t work! Check the following:
1. Is the PDP Display power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?
Switching Your PDP Display On and Off
The power cord is attached to the rear of the PDP Display.
1 Plug the power cord into an appropriate socket.
➢ The main voltage is indicated on the rear of the PDP Display and the frequency is 50 or 60Hz.
2 Press the (Power) button (On/Off) on the front of the PDP Display or press the ON button on the
remote control to switch the PDP Display on.
3 To switch the PDP Display off, press the (Power) button (On/Off) on the front of the PDP Display or
press the OFF button on the remote control.
BN68-01364A-02Eng_1009.indd 8 2007-10-09 ¿АИД 2:24:00