Samsung SE-S164L-AMBN - Manual (Page 27)

Select Languages
English
Category
SE-S164L
External DVD Writer
DISC
Usable Discs
DVD :DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM,
DVD-Video, DVD+R (Dual), DVD-R (Dual), Light
Scribe DVD±R , DVD-RAM
CD : CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G)
CD-MIDI, CD-TEXT, CD-ROM XA, Mixed Mode CD
CD-I, CD-I Bridge (Photo-CD, Video-CD),
Multisession CD (Photo-CD, CD-EXTRA, Portforio),
Light Scribe CD-R
Disc Diameter 4.72 Inch or 3.15 Inch (120mm or 80mm)
Interface Support Interface Port USB 2.0
ACCESS TIME
(Random)
CD-ROM 110ms (Random)
DVD-ROM 130ms (Random)
Disc
Labeling
Time
Setting Titles only Titles and contents
The entire label area
(including graphics)
Best Less than 4 min Less than 9 min Less than 36 minutes
Normal Less than 3 min Less than 7 min Less than 28 minutes
Draft Less than 2 min Less than 4 min Less than 20 minutes
Data Transfer Speed
(Max)
Media Type Write Read
DVD+R PCAV 16X (21.6MB/sec) CAV 12X (16.2MB/sec)
DVD+RW Z-CLV 8X (10.8MB/sec) CAV 8X (10.8MB/sec)
DVD+R DUAL Z-CLV 8X (10.8MB/sec) CAV 8X (10.8MB/sec)
DVD-R DUAL CLV 4X (5.4MB/sec) CAV 8X (10.8MB/sec)
DVD-R PCAV 16X (21.6MB/sec) CAV 12X (16.2MB/sec)
DVD-RW Z-CLV 6X (8.1MB/sec) CAV 8X (10.8MB/sec)
DVD-ROM(Single) - CAV 16X (21.6MB/sec)
DVD-ROM(Dual) - CAV 8X (10.8MB/sec)
DVD-RAM PCAV 5X(6.75MB/sec) CAV 5X(6.75MB/sec)
CD-ROM - CAV 48X (7.2MB/s)
CD-R PCAV 48X (7.2MB/sec) CAV 40X (6.0MB/sec)
US-RW Z-CLV 32X (4.8MB/sec) CAV 40X (6.0MB/sec)
HS-RW CLV 10X (1.5MB/sec) CAV 40X (6.0MB/sec)
CD-RW CLV 4X (0.6MB/sec) CAV 40X (6.0MB/sec)
Buffer Memory 2MB
Drive Installation Horizontal / Vertical
Operating
Environment
Temperature 41°F ~ 104 °F (5°c ~ 40°C)
Humidity 10% ~ 80% (RH)
Size(Width x Height x Length) 6.41 X 1.96 X 9.13 Inch (163 X 50 X 232mm)
Weight 1,200g
Note
Does not support DVD-R for Authoring.
Cannot playback or record on both sides of a two-sided disc simultaneously.
The read/write capacity of the supported discs depends on the condition of the disc
and the recording format of the drive. Therefore, the read/write quality may not be perfect.
Severe vibration or external impact may decrease the quality of printed images.
Please firmly place the product onto the PC before use.
In case of disc identification error message, thoroughly clean the surface of the disc
where the label is presented and then start printing.
The quality of the printed image cannot be ensured if printing an image on the area
which is already used for printing.
For more information on the writing and duplicating the Lightscribe disk label,
install Nero software and refer to the HELP section.