Samsung PN50A400C2DXZA - Manual (Page 13)

English - 1
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a cable TV system
(according to the instructions on pages ~10). Skip step 1 if you have not yet connected to an antenna or a cable
system.
➢ If you have a “mono” (non-stereo) VCR, use a Y-connector (not supplied) to
connect to the right and left audio input jacks of the TV. Alternatively, connect the
cable to the “R” jack.
If your VCR is stereo, you must connect two cables.
➢ Each VCR has a different back panel configuration.
➢ When connecting a VCR, match the color of the connection terminal to the cable.
➢ When connecting to AV IN 1, the color of the AV IN 1 [Y/VIDEO] jack (Green) does
not match the color of the video cable (Yellow).
VCR Rear Panel
TV Rear Panel

Audio Cable(Not supplied) 5
Video Cable(Not supplied) 4
Antenna cable(Not supplied) 
1 Unplug the cable or antenna
from the back of the TV.
 Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
 Connect an Antenna Cable
between the ANT OUT
terminal on the VCR and the
ANT IN terminal on the TV.
4 Connect a Video Cable
between the VIDEO OUT
jack on the VCR and the AV
IN 1 [Y/VIDEO] jack on the
TV.
5 Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the AV
IN 1 [R-AUDIO-L] jacks on
the TV.
BN68-01814A-Eng.indb 13 2008-07-28 오후 3:45:29