Samsung HT-H4500-ZA - Manual (Page 12)

12
- English
Settings
The Initial Settings Procedure
!
The Home menu will not appear if you do not
configure the initial settings.
! The OSD (On Screen Display) may change in
this product after you upgrade the software
version.
! The access steps may differ depending on the
menu you selected.
1. Turn on your TV after connecting the product,
and then turn on the product. When you turn
on the product for the first time, the product
automatically displays the Initial Settings
Language screen.
2. Press the ▲▼ buttons to select the desired
language, and then press the v button.
3. Press the v button to start function setup.
Initial Settings
TV Aspect and Network will be set.
Each setting may be changed later under "Settings"
a Previous " Select
Start
4. The Tv Aspect screen appears. Press the ▲▼
buttons to select a TV aspect ratio, and then
press the v button.
You have four choices:
16:9 Original - For widescreen TVs. Displays
widescreen pictures in their original 16:9 format
and 4:3 pictures (the old, standard format) in
4:3 pillar box format with black bars on the left
and right.
16:9 Full - For widescreen TVs. Displays
widescreen pictures in their original 16:9 format
and expands 4:3 pictures to fill the 16:9 screen.
4:3 Letter Box - For older, standard screen,
analog TVs. Displays 4:3 pictures in full screen
and 16:9 pictures in letter box format that
retains the 16:9 aspect ratio but puts black bars
above and below the picture.
4:3 pan-Scan - For older, standard screen,
analog TVs. Displays 4:3 pictures in full screen
and 16:9 pictures in Pan-Scan format that fills
the screen, but cuts off the left and right sides
of the picture and enlarges the middle vertically.
5. The Network - Wired screen appears.
- If you have a network with dynamic IP
addresses - and most people do - select Auto,
press the v button, and then go to Step 6.
- If you have a network with static IP addresses,
we suggest you select Skip by pressing the
BLUE (d) button. (See page 16)
- If you have no network, select Skip by
pressing the BLUE (d) button. The Initial
Settings Complete screen appears, and then
the Home screen appears.
✎ If you skip network setup here or the setup
does not work correctly, you can set up the
product's network connection later. (See page
16)
Initial Settings | Network - Wired
Auto Manual
Choose the method to configure Internet Protocol (IP). Please make sure that the Ethernet
cable is connected.
Auto : Configure IP automatically.
a Previous d Skip < Move " Select
6. The product verifies the network connection
and then connects to the network. When it is
done, press the v button. The "Initial settings
completed." screen appears, and then the
Home screen appears.
Initial Settings | Network - Wired
MAC Address (d0:66:7b:dc:28:fc)
IP Address, Subnet Mask, Gateway, DNS Server
Gateway Ping
Internet Service Test
" Select
OK
Your network is operating properly. If you still have a network problem, contact your
network service provider.