Samsung LS23EMNKUY-ZA - Manual (Page 34)

English - 32
Troubleshooting for Anynet ¦
+
Problem Possible Solution
Anynet+ does not work. Check if the device is an Anynet ● + device. The Anynet+ system
supports Anynet+ devices only.
Connect only one receiver (home theater). ●
Check if the Anynet ● + device power cord is properly connected.
Check the Anynet ● + device’s Video/Audio/HDMI 1.3 cable
connections.
Check whether Anynet ● + (HDMI-CEC) is set to On in the
Anynet+ setup menu.
Check whether the TV remote control is in TV mode. ●
Check whether it is Anynet ● + exclusive remote control.
Anynet ● + doesn’t work in certain situations. (Searching
channels, Operating, Plug & Play, etc.)
When connecting or removing the HDMI 1.3 cable, please ●
make sure to search devices again or turn your TV off and on
again.
Check if the Anynet ● + Function of Anynet+ device is set on.
I want to start Anynet+. Check if the Anynet ● + device is properly connected to the
TV and check if the Anynet+ (HDMI-CEC) is set to On in the
Anynet+ Setup menu.
Press the TV button on the TV remote control to switch to TV. ●
Then press the TOOLS button to show the Anynet+ menu and
select a menu you want.
I want to exit Anynet+. Select View TV in the Anynet ● + menu.
Press the SOURCE button on the TV remote control and select ●
a device other than Anynet+ devices.
Press ● z, CH LIST, PRE-CH, and FAV.CH to change
the TV mode. (Note that the channel button operates only when
a tuner-embedded Anynet+ device is not connected.)
The message Connecting
to Anynet+ device...
appears on the screen.
You cannot use the remote control when you are configuring ●
Anynet+ or switching to a view mode.
Use the remote control when the Anynet ● + setting or switching
to view mode is complete.
The Anynet+ device does
not play.
You cannot use the play function when Plug & Play is in ●
progress.
The connected device is
not displayed.
Check whether or not the device supports Anynet ● + functions.
Check whether or not the HDMI 1.3 cable is properly ●
connected.
Check whether Anynet ● + (HDMI-CEC) is set to On in the
Anynet+ setup menu.
Search Anynet ● + devices again.
You can connect an Anynet ● + device using the HDMI 1.3 cable
only. Some Some HDMI cables may not support Anynet+
functions.
If it is terminated by an abnormal situation such as ●
disconnecting the HDMI cable or power cord or a power failure,
please repeat the device scan.
The TV program cannot
be recorded.
Check whether the antenna jack on the recording device is ●
properly connected.
The TV sound is not
output through the
receiver.
Connect the optical cable between TV and the receiver. ●