Samsung WF438AAR-XAA - Manual (Page 26)

26_ Troubleshooting
ERROR IMAGE MEANING SOLUTION
Power Interruption
Error!
Problem with control. Call for service.
Water Supply
Problem
Error!
A fault is detected in the water level
sensor. Call for service
A button is either stuck
or is being pressed
continuously.
Error!
Jammed Key. Call for service
The motor is not
working properly.
Error!
• Motor speed sensor problem.
• High current detected.
• Motor not running properly. Restart the cycle pressing the Start/
Pause Button. If the code reappears,
call for service.
Temperature Sensor
Problem
Error!
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service.
High/Low Voltage
Delected
Error!
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service.
SilverCare TM
Error!
SilverCare™ control problem Restart the cycle.
If the code reappears, call for service.
Excessive Suds
Error!
Too many suds are detected during the
washing session.
The unit is put on hold until the suds
are reduced. Then, the unit will go back
to the operation.
When it finishes washing, End and
SUdS codes will blink in turn. To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
troubleshooting
WF448AAW-02535A-02_EN.indd 26 2008-05-06 ¿АИД 2:23:37