AudioBahn AT61J - Manual (Page 6)

Wiring
5
Audiobahn recommends using at least 18-gauge wire with your new speaker system.
Thinner gauge wire may easily be severed and can cause damage to your system
should any bare wires come in contact with the vehicles chassis.
Makes sure that your audio system is off while installing and connecting your new Au-
diobahn Speakers. Failure to do so could result in damaging the speaker beyond repair.
This is not something that would be covered under the manufacturer warranty.
Be sure to route the wires to the speakers with the insulated terminal ending at the
speaker. This will insure a good contact with the speaker. If you need to shorten the
speaker lead, do so on the opposite end of the insulated terminals or the bare end.
Be sure the polarity is correct at all times. The speaker leads are color coded for nega-
tive and positive. Make sure that the leads connected to the positive terminal of your
amplifier or source unit is correctly connected to the positive terminal of the speaker.
To insure long-term reliability all bare wires and wire-to-wire connections should be
soldered and insulated with heat shrink or electricians tape. Under no circumstances
should you leave any bare wires uncovered, as this can and will lead to the failure of
your speakers and possibly other components.
When mounting in a door it is imperative to have the right amount of slack in the con-
necting wire as to not get crimped or torn when the door is opened or closed. Avoid
areas of the door jam that pinch. This will cause damage to the speaker and other com-
ponents over long-term use.
Once the speaker wiring is complete, you can connect the opposite end to the amplifier
or source unit. Again, be sure to observe correct polarity. Solder and wrap all stripped
connections.