Samsung RF24FSEDBSR - Manual (Page 141)

setting up _21
01 SETTING
UP
Parts for water line Installation
Water line fi xer and screws Pipe connector
Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifi er to malfunction.
Close Main Close Main
Water pipe
Water pipe
Close Main Close Main
Water pipe
Water pipe
No gap No gap
4. After connecting the water supply to the water
fi lter, turn your main water supply back on
and dispense about 3L to clear and prime the
water fi lter.
Connecting the water line to the
refrigerator
1. Remove the cap from the water line on the unit
and insert the compression nut of the water
line into the water line on the unit.
2. Connect the water line on the unit with the
water line in the kit .
3. Tighten the compression nut onto the
compression fi tting. There should be no gaps
between (A, B & C )
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.5mm
of the plastic tubing to make sure you get
a snug, leak-free connection.
Remove Remove
cap
cap
Water Line Water Line
from unit
from unit
Water Line Water Line
from Kit
from Kit
No gap No gap
Loosen a Loosen a
Before being used, the leakage in these
places should be examined.
• Samsung Warranty does not cover
WATER LINE
INSTALLATION.
• It will be done at
customer’s charge
unless the retail
price includes
installation cost.
• Please contact Plumber or Authorized Installer
for the installation if needed.
• If Water leakage occurs due to improper
installation, Please contact installer.
CAUTION
DA68-02916G-08.indb 21 DA68-02916G-08.indb 21 2014. 6. 20. 9:20 2014. 6. 20. 9:20