Nilfisk-ALTO DJM-3 - Manual (Page 10)

3.2 The Front Panel
MIC IN PHONE OUT
REVERSE HOLD
REVERSE TAP
CROSSFADER
CURVE
SMOOTH SHARP
9
23 24 25 26
3.2.1 MIC IN Jack
This input will accept and unbalanced low impedance microphone. The functions of the microphone will be
controlled by the MIC INPUT section on the Top Panel.
23
3.2.2 The PHONE OUT Jack
This input will accept a standard headphone with a 1/4" stereo jack
24
3.2.3 The REVERSE Switch
This switch will invert the direction of the crossfader so that an immediate inversion of the two channels will
be achieved. This switch has two functions: TAP and HOLD.
In TAP function the 2 channels will be reversed instantly and will go back in their original set as soon as you
release the switch in center position
In HOLD function the two channels will be locked in the reverse position. To cancel the effect you will need
to push back the switch in the center position.
25
3.2.4 CROSSFADER CURVE Control
Via this knob you will adjust the crossfader curve. Please see (5) earlier in this Manual for further reference.
26