Audiovox FR-1500XTM - Manual (Page 6)

6
Accessories
SUPPLIED: (1) Belt Clip
OPTIONAL: (1) Headset P/N FRS-BHST
NOTE:
To order optional accessories for the
FR-1500XTM, please contact Customer Service
at 1-800-290-6650 or visit the Audiovox web site
at www.audiovox.com.
Powering the FR-1500XTM Unit:
The FR-1500XTM unit operates on four AAA batteries installed in the battery compart-
ment. You may operate the unit using type NiMH rechargeable batteries , or you may
use Alkaline batteries. Alkaline batteries will provide slightly better performance than
the rechargeable batteries. The rechargeable batteries can not be recharged while in
the unit.
Installing the Batteries:
Installing batteries in the FR-1500XTM unit is straightforward as shown in the
following illustration.
1. Remove unit from belt clip, and simply unlatch the cover clip at the bottom rear
of the unit; lift off the battery compartment cover.
2. Remove the weak batteries, if present.
3. Install four AAA batteries and carefully note battery polarity as marked within
the battery compartment.
NOTE: When the last battery is installed in place, the unit will vibrate for
approximately 2 seconds, indicating battery installation is correct,
and the self-test display will appear momentarily, then fade out.
4. Slide up the battery compartment cover in place; swing up the cover retaining
clip and snap it into position.
Belt Clip Accessory
SPRING CLIP
RELEASE TAB
(PRESS DOWN) SPRING
CLIPS SPRING-
LOADED
BELT CLIP