Samsung PS43D490A1W User Manual
Page 8
English - 8
Plug & Play (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings.
Press the
POWER
P button. Plug & Play is available only when the Source is set to TV.
✎
Before turning on the TV, make sure the antenna cable is connected (p. 6).
✎
To return to the previous step, press the Red button.
1
Selecting a language Press the
▲ or ▼ button, then press the
ENTER
E button.
Select the desired OSD (On Screen Display) language.
2
Selecting Store
Demo or Home Use
Press the
◄ or ► button, then press the
ENTER
E button.
Select the Home Use mode. Store Demo mode is for retail
environments.
To return the unit’s settings from Store Demo to Home Use
(standard): Press the volume button on the TV. When you see the
volume OSD, press and hold
MENU
for 5 sec.
Store Demo is only for shop display. If you select it, several
functions are not able to use. Please select Home Use when you
watch at home.
3
Selecting a country
Press the
▲ or ▼ button, then press the
ENTER
E button. Select the
appropriate country. (depending on the country)
✎
After selecting the country in the Country menu, some models may proceed
with an additional option to setup the pin number.
✎
When you input the PIN number, “0-0-0-0” is not available.
4
Setting the Clock
Mode
Set the Clock Mode automatically or manually.
Auto: Select the time zone where you are located.
Manual: Allows you to manually set the current date and time.
5
Selecting an antenna Press the
▲ or ▼ button, then press the
ENTER
E button. Select the Antenna
source to memorise.
6
Selecting a channel
Press the
▲ or ▼ button, then press the
ENTER
E button. Select the channel
source to memorise. When setting the antenna source to Cable, a step appears
allowing you to assign numerical values (channel frequencies) to the channels. For
more information, refer to Channel
→ Auto Tuning.
7
Enjoy your TV.
Press the
ENTER
E button.
If You Want to Reset This Feature...
You should do Plug & Play (
MENU
→ System) again at home although you did in shop.
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”
(except France). If you want to change the PIN number, use the Change PIN function.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode,
which resets the PIN to “0-0-0-0” (France: “1-1-1-1”):
MUTE
→ 8 → 2 → 4 →
POWER
(on).
P
POWER
[PD490-XN_ZF]BN68-03497E-02L04.indb 8
2011-03-07 오후 5:24:24