Connecting the dome lights, Positive switched dome lighting – Movies2Go MMD11A User Manual

Page 9

Advertising
background image

9

CONNECTING THE DOME LIGHTS

The dome lights in the video monitor require three connections to the vehicle's wiring. There are
two common types of dome light circuits used, positive or negative switched. Positive systems
supply voltage to the interior lights to turn them on, negative switched systems apply ground to
illuminate the bulbs. To determine which system you have you must locate the wires at the dome
light. On a positive switched system, with all the doors closed and the lights out, both wires at the
dome light will rest at ground. When the light is activated, one of these wires will switch to +12
vdc. This is the vehicle's switching wire. On a negative switched system, with all the doors
closed and the lights out, both wires at the dome light will rest at + 12vdc. When the light is
activated, one of these wires will switch to ground. This is the switching wire.

For positive systems, connect the purple / brown (Lamp auto) wire to the vehicle's switched wire.
Then connect the red / black (lamp on) wire to a fused constant 12 volt source and the black / red
(lamp common) wire to a good ground. Positive systems are commonly found on Ford vehicles.

For negative systems, connect the purple / brown (Lamp auto) wire to the vehicle's switched
wire. Then connect the red / black (lamp on) wire to a good ground and the black / red (lamp
common) wire to fused constant 12 volt source. Negative systems are commonly found on
General Motors and import vehicles.

Note: Some vehicles which incorporate transistorized control of the dome light circuit, such as
the 1999 Dodge Caravan, may require that the purple / brown (Lamp auto) wire be connected to
the door pin switch wire, as the additional current draw of the Monitor's lights may not be
supported by the output of the vehicles body control computer.

Positive Switched Dome Lighting

Red / black - Lamp on

Factory Dome light circuit

To 12 pin

connector

on Monitor

To

constant

+12vdc

To

constant

+12vdc

Black / red - Lamp common
Purple / brown - Lamp Auto

Factory Door ajar
switch or Body
Control computer

Advertising