AGFA sensor 500-X - Manual (Page 48)

43
Troubleshooting
Problem Cause Solution
Batteries are inserted in the
wrong direction.
Reload batteries in the correct
direction.
Batteries are dead. Replace or recharge batteries.
Power does not turn camera
on.
The battery compartment door
is open.
Make sure the battery
compartment door is securely
closed.
The flash is charging. Wait for the flash to charge.
Memory is full. Insert a new memory card.
The camera does not take
pictures.
Memory card is not formatted
correctly.
The card may be defective:
use a new card.
The flash is charging. Wait for the flash to charge. Image is not recorded when
the shutter button is pressed. Memory is full. Insert a new memory card.
The flash does not fire. Flash is set to OFF. Set the flash to any mode
except off.
The image is blurred or out of
focus.
The camera was moving when
the image was captured.
Hold the camera steady when
shooting a picture.
The image is not displayed on
the LCD monitor.
A memory card with non-PICT
images (recorded with another
camera) is loaded.
This camera cannot display
non-PICT images.
Recorded images are not
saved in memory.
The camera was turned
off/powered down before
saving images to the memory.
If the battery low indicator
appears on the LCD monitor,
replace the battery
immediately.