AFX BBSS17051400L30D2SA - Manual

BBSS LED Sconce
LED Wall Sconce
Model: BBSS17051400L
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120 VAC, 60Hz fused circuit and
is dimmable with many standard 2-wire, triac dimmers.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing
or servicing any part of this fixture.
B. Separate contents of cartons and hardware bag.
C. Mount gem bar (1) to junction box (not
provided) with screws provided. Adjust
locknut on threaded stem (2) so that approx.
¾” of stem is exposed.
2. Wiring.
Caution: Make sure power is off at fuse or circuit
breaker box. Check power wires for damage or
scrapes. If power supply wires are within three
inches of ballast use wire suitable for at least 90C
(194F). Note: Most dwellings built before 1985
have supply wire rated to 60C. Consult a qualified electrician before installing.
A. This unit will not operate properly unless connected to a “grounded” electrical circuit. Electrical shock, over heating,
low or no light output, and shortened lamp life can result if proper grounding is not done. Securely attach green (or
green and yellow) wire to provided green ground screw.
B. For models designed to run on 120V only: Using wire nuts (provided), connect white supply wire to white ballast lead.
Connect black hot supply wire to black ballast lead. Do not mix wires. Pull on each wire lead to make sure connection
is secure. Make certain no bare wires are exposed outside of wire nuts.
C. For models designed to run on 120-277V: Using luminaire disconnect (provided and pre-wired to ballast leads), insert
white supply wire into the hole across from white ballast lead. Insert black hot supply wire into hole across from black
ballast lead. Do not mix wires.
D. Install wire way assembly (3) over stem and secure with knob (4).
3. Diffuser mounting.
A. Position frame assembly (5) over the mounted wire way assembly, align holes and secure with four frame-mounting
screws (6).
Power to the fixture can now be restored.
Limited Factory Warranty
AFX Inc. hereby warrants that this fixture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 3 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective
fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
Page 1 of 1 8060790 Rev 0
Fluorescent Model Shown