AFX EPS0524124PMVPC - Manual

EPS Series
Fluorescent Wall Sconce
Model 124
Page 1 of 1
8060517 Rev 2
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120-277V AC, 60Hz fused
circuit. Do not use on a dimming circuit. Make sure that the power
source conforms to the requirements of the fixture. (See labels on
fixture housing)
To reduce the risk of electrical shock, and to assure proper operation, this
fixture must be adequately grounded. To accomplish proper grounding, there
must be a separate ground wire (green) or bare metal contact (metal conduit)
between this fixture and the ground connection of your main power supply
panel. The green ground screw location is clearly marked on the fixture
housing.
This fixture is intended to be used for general indoor lighting in
dry or damp locations only.
Assembly Instructions
1. Preparing for installation-
A. Disconnect electrical power before installing or servicing any part of this
fixture.
B. Remove diffuser assembly (6) and back pan (1) from carton. Separate contents
of hardware bag.
2. Wiring- all wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check power wires for
damage or scrapes. If power supply wires are within three inches of ballast use wire
suitable for at least 90C (194F). Note: Most dwellings built before 1985 have supply
wire rated to 60C. Consult a qualified electrician before installing.
A. Securely attach fixture green (or green and yellow) wire to ground wire from
junction box.
B. Using luminaire disconnect (provided), insert white supply wire into the hole
across from white ballast lead. Insert black hot supply wire into hole across
from black ballast lead. Do not mix wires. Pull on each wire to make sure
connections are secure. Make certain no bare wires are exposed outside of
luminaire disconnect.
3. Mounting-
A. Center fixture to junction box and mark locations for mounting.
B. Mark and drill hole locations to use provided anchors.
C. Attach back pan to wall using the mounting screws (3) and anchors (5) provided
and/or secure to junction box if available with gem bar (included – not
pictured).
4. Lamp - Install appropriate lamp; 4-pin 2G11 base 24 watt (2 - not provided) per
label on face of backpan. Insert lamp pins into lamp holder (9) and press downwards
until lamp snaps in place.
5. Diffuser Assembly - To install the diffuser assembly, slide the assembly to attach
bracket (4) on back pan and tighten screw (8) with rubber washer (7) first into hole
location on the top side of the diffuser assembly (6) to back pan (1).
6. Restore power at fuse or circuit breaker box.
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal
operating conditions for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.