Allied Telesis AT-8100 Series - Manual (Page 284)

Chapter 25: LLDP and LLDP-MED
284
Enabling and Configuring LLDP on the Switch
To enable LLDP and set the basic LLDP configuration on the switch, do
the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 122.
Figure 122. Discovery & Monitoring Tab
2. From the Discovery & Monitoring tab, hover over LLDP.
The LLDP tab appears to the right.
3. From the LLDP tab, move the cursor to the right and select Basic
Configuration from the drop-down menu.
The LLDP Configuration page is displayed. See Figure 123 on page
285.