Allied Telesis AT-IMC1000T/SFP - Manual (Page 13)

Mounting Installation DIN-Rail Mounting
13 AT-IMC1000T/SFP Industrial Gigabit PoE+ Media Converter User Manual
3. Mounting Installation
3.1 DIN-Rail Mounting
The DIN-Rail clip is screwed on the AT-IMC1000T/SFP Industrial Media Converter when out of factory. If the DIN-
Rail clip is not installed on the back of the media converter, please see the following figure to screw the DIN-Rail on
the switch. Follow the below steps to hang the industrial switch.
1. Use the screws to screw on the DIN-rail clip on the industrial switch.
2. To remove the DIN-rail clip, reverse step 3.1.1.
FIGURE 3-1 DIN-Rail Mounting
3. Align the top of the chassis DIN-Rail clip on the rear of the chassis with the top track of the DIN-Rail. See
Figure 3-1