Allied Telesis AT-2701 Series - Manual (Page 4)

AT-2701 Series Fast Ethernet Network Adapters Linux Configurations
PN 613-001846 Rev A 4 Allied Telesis, Inc.
Note
Replace "eth x " with the name of the Ethernet interface that you obtained
in step 2 and xx:xx:xx:xx:xx:xx with the hardware address of your
adapter. "eth x " appears twice in the file.
5. Save the ifcfg-eth x file.
6. Repeat step 3 to 5 for all of the Ethernet interfaces of AT-2701 series adapters
on your system.
7. Reboot your Linux system.
8. Verify that your AT-2701 series adapter is running 100 Mbps in the full-duplex
mode by entering the following command:
ethtool eth x
The command output should display:
Advertised Auto-Negotiation is No
Speed is 100
Duplex mode is Full
9. Repeat step 8 for all of the Ethernet interfaces of AT-2701 series adapters on
your system.