Allied Telesis AT-IX5-28GPX - Manual (Page 113)

IX5-28GPX Installation Guide
113
To install an SFP or SFP+ transceiver, perform the following procedure:
1. Remove the dust plug from a transceiver slot on the switch.
Figure 64 on page 113 shows the dust plug being removed from a port.
Figure 64. Removing the Dust Plug from an SFP+ Slot
Note
When VCStack is enabled on the switch, slots S1/27 and S2/28 are
reserved as stacking ports and may not be used for regular SFP or
SFP+ transceivers.
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. If you are installing the transceiver in a top slot, position the transceiver
with the Allied Telesis label facing up. If you are installing the
transceiver in a bottom slot, position the transceiver with the label
facing down.
S2/2
8
S1
/27
26
25
CON
SO
LE
SF
P+
2675