Allied Telesis AT-GS900/8 - Manual (Page 37)

AT-GS900/8 Gigabit eco-friendly Ethernet Switches Installation Guide
37
Installing the Switch in a Rack
Perform the following procedure to install the switch in a standard 19-inch
rack. If you are not installing the switch in a rack, go to the next procedure.
1. Place the unit upside down on a level, secure surface.
2. If they have been previously installed, remove the self-adhesive rubber
feet from the bottom of the switch, as shown in Figure 9 using a flat-
head screwdriver.
Figure 9. Removing the Feet
3. Turn the switch over.
4. Attach the two rackmounting brackets (provided) to the sides of the
switch using the eight flathead Phillips screws (provided), as illustrated
in Figure 10.
Figure 10. Attaching Rack Mounting Brackets
AT-GS900
/8 8 Port 1 0/100/1 000Base -T Gigab it Ether net Swit ch
1 2 3 4 5 6 7 8
POWER 10/100 L INK ACT
1000 LIN K ACT
FDX HDX COL
1 2 3 4
6 7 8
5
1918