Allied Telesis AT-S105 - Manual (Page 40)

Chapter 2: Basic Switch Parameters
40
Rebooting a Switch
This procedure reboots the switch and reloads the AT-S105 Management
software from flash memory. You may want to reboot the device if you
believe it is experiencing a problem.
Caution
The switch does not forward network traffic during the reboot
process. Some network traffic may be lost.
To reboot a switch, do the following procedure:
1. From the main menu on the left side of the page, select the Tools
folder.
The Tools folder expands.
2. From the Tools folder, select Reboot.
The Reboot Page is displayed. See Figure 13.
Figure 13. Reboot Page
3. For the Reboot Type, select Normal from the pull-down menu. This is
the default setting.
Note
Two additional Reboot Type options, Factory Default and Reset to
Factory Default Except IP Address, are described in “Returning
the AT-S105 Management Software to the Factory Default Values”
on page 44.
4. For the Reboot Status, use the pull-down menu to select Start to
begin the reboot.
5. Click Apply.