Replacing a line card or the management card – Allied Telesis AT-CV1203 User Manual
Page 36
Chapter 2: Installation
36
Replacing a Line Card or the Management Card
All the Converteon media converter line cards and the AT-CV5M02
Management Card support hot-swapping and can be installed while the
chassis is powered on.
To replace a line card, perform the following procedure:
1. Disconnect all the cables from the line card you want to remove from
the chassis.
2. Insert the dust cap into the fiber optic port on the line card.
3. Using a Phillips-head screwdriver, loosen the captive screw of the line
card.
4. Slide the line card from the chassis.
5. If you are replacing the line card, go to “Installing a Converteon Line
6. If you are not replacing the line card, insert the AT-CV5PNL1 slot
cover in the slot and tighten the captive screw to secure it to the
chassis.