Allied Telesis AT-GS950/8 - Manual (Page 41)

AT-GS950/8 Gigabit Ethernet WebSmart Switch Installation Guide
41
Connecting the
Fiber Optic
Cables
To connect a fiber optic cable to an SFP transceiver installed in the
AT-GS950/8 switch, perform the following procedure:
1. Remove the dust plug from the SFP transceiver, as shown in
Figure 16.
Figure 16. Removing the Dust Plug from the SFP Transceiver
2. Connect the fiber optic cable to the SFP port, as shown in Figure 17.
Figure 17. Connecting the Fiber Optic Cable
Powering On the
Switch
To power on the switch, perform the following procedure:
1. Plug the power cord into the AC power connector on the back of the
switch, as shown in Figure 18 on page 42.
925
926