Allied Telesis AlliedView-EMS 3.11 AMIGO - Manual (Page 26)

AlliedView™-EMS 3.11 AMIGO USERS GUIDE Page 26 of 43
Port number
The UDP port number on which the target device is listening for SNMP messages. If
the target device is using a non-standard port for SNMP operations, you must
change this value.
SNMP version
The version of SNMP that the device will use to send and receive device
information. After choosing the version of SNMP to use, click on the Settings button
to specify the SNMP parameters that correspond with the chosen version. If the
SNMP version is set to "v1" or "v2c", then the SNMP v1/v2c Settings dialog box will
be displayed. Otherwise, if the SNMP version is set to "v3", then the SNMP v3
Settings dialog box will be displayed.
Target Host Property dialog box
4.1.6.3.1 SNMP v1 / v2c Settings
Community for read/Community for write
The community strings used to perform SNMP operations on the device.
SNMP v1/v2c Settings dialog box