Allied Telesis AT-S65 - Manual (Page 40)

Chapter 2: Basic Parameters
40
Changing the RS-232 Terminal Baud Rate
The default settings for the RS-232 terminal port are:
ˆ Baud rate: 115200
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
To set the RS-232 port to a different baud rate, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is shown in Figure 4 on page 22.
2. From the System Configuration Menu, select Terminal Configuration
and press Enter.
The Terminal Configuration menu is shown in Figure 17.
Figure 17. Terminal Configuration Menu
3. From the Terminal Configuration Menu, select Data Rate and press
Enter.
Terminal Configuration Menu
Data Rate (Baud Rate)
Return to System Configuration Menu ...