Allied Telesis AT-S97 - Manual (Page 115)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
115
NTP ENABLE
Syntax
ntp enable
Parameters
None.
Privilege Levels
Administrator and read-write.
Description
This command activates the NTP client on the management module. The
client polls for the NTP server, making fifteen attempts over twenty
seconds to contact the device. The default setting for the client is disabled.
To set the IP address of the NTP server, use “NTP SET” on page 116.
Note
Review “NTP Client Guidelines” on page 112 before activating the
client.
Caution
If you enable the NTP client before you connect an NTP server to
the AT-MCF2000 chassis, the system appears to hang.
Example
ntp enable