Allied Telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT - Manual (Page 265)

AlliedView™-EMS 3.10 Device Management Guide Page 265 of 367
Port Mirroring
Displays port mirroring parameters and allows configuration of port mirroring status,
destination port, Ingress source port and Egress source port.
Note - The current firmware version does not allow the Mirroring Source Port
(Ingress) and Mirroring Source Port (Egress) parameters to be configured.
QoS
Basic Config
Displays QoS parameters and allows enabling of Hol prevention status and setting of
scheduling mechanism.
Scheduling Mechanism
Displays scheduling mechanism parameters.
802.1p Default Priority
Displays the 802.1p default priority table..
802.1p User Priority
Displays the 802.1p user priority class table.
User Priority Regeneration
Displays the regenerated user priorities table.
Traffic Class
Displays the traffic class table.
Outbound Access Priority
Displays the outbound access priority table.
Bandwidth Control
Displays the bandwidth control table.
Note - Valid MIB Set values for the Receive Rate and Transmit Rate parameters are
in the range [1-10000] inclusive. However, specifying a value greater than 999 will
automatically set these parameters to 999.
Port Trunking
Basic Info
Displays basic information about port trunking.
Trunk Config
Displays port trunking parameteres and allows configuration of the master port,
member ports, trunk type and trunk status.
Note - The current firmware version does not allow the Member Ports and Trunk
Type parameters to be configured.