Disable switch port – Allied Telesis AT-S63 User Manual
Page 108
Advertising
Chapter 6: Port Parameter Commands
108
Section I: Basic Operations
DISABLE SWITCH PORT
Syntax
disable switch port=
port
Parameter
port
Specifies the port to disable. You can specify more than
one port at a time. You can specify the ports
individually (for example, 5,7,22), as a range (for
example, 18-23), or both (for example, 1,5,14-22).
Description
This command disables a port. When a port is disabled, it stops forwarding
traffic. The default setting for a port is enabled.
Example
The following command disables ports 12 and 24:
disable switch port=12,24
Equivalent Command
set switch port=
port
status=disable
For information, see “SET SWITCH PORT” on page 115.
Advertising