Allied Telesis AT-EN646MOD Enclosure - Manual (Page 11)

AT-EN646MOD Installation Guide
Chapter 3: Enclosure Installation 11
Mount the Enclosure
To mount the AT-EN646MOD enclosure, perform the following procedure:
1. Remove all components from the shipping package.
2. Choose an outdoor location (indoor mounting is also acceptable) for the enclosure that is close to the
power source. The enclosure must be mounted within 50 cable feet of the power supply.
3. Using the enclosure as a template, mark the three mounting holes on the wall, as shown in Figure 4, and
prepare a mounting hole in the wall for each opening.
Figure 4. Mounting Hole Locations
4. Use #8 or larger hardware (not provided) to mount the enclosure on the wall.
Make sure that the enclosure is square to the surface. If it is not, shim with washers to prevent
warping.