Set qos cosp – Allied Telesis AT-S63 User Manual
Page 303
AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations
303
SET QOS COSP
Syntax
set qos cosp=
priority-number
qid=
queue-number
Parameters
cosp
Specifies a Class of Service (CoS) priority level. The CoS
priority levels are 0 through 7, with 0 as the lowest priority
and 7 as the highest. You can specify more than one
priority to assign to the same egress queue.
qid
Specifies the egress queue number. The egress queues
are numbered 0 through 7, with queue 0 as the lowest
priority and 7 as the highest.
Description
This command maps CoS priorities to port egress queues. You must
specify both the priority and the queue ID. You can assign more than one
priority to an egress queue. Table 11 on page 300 lists the default
mappings between the eight CoS priority levels and the eight egress
queues of a switch port.
Example
The following command maps priorities 5 and 6 to egress queue 1:
set qos cosp=5,6 qid=1
Equivalent Command
map qos cosp=
priority-number
qid=
queue-number
For information, see “MAP QOS COSP” on page 300.