Allied Telesis AT-S84 - Manual (Page 217)

AT-S84 Management Software User’s Guide
Section II: Web Browser Interface 217
Configuring SNTP
To configure SNTP, perform the following procedure:
1. From the Basic Configuration menu, select SNTP Configuration.
The SNTP Configuration page is shown in Figure 61.
Figure 61. SNTP Configuration Page
2. In the SNTP Server IP field, type the IP address for the SNTP server
you want to use.
3. In the Set SNTP Interval field, type a number to specify the number of
minutes between occurrences of polling the SNTP server. The range is
1 to 60 minutes and the default is 1 minute.
4. To set the time zone, select one from the Time Zone list.
5. For the Daylight Saving parameter, choose one of the following from
the list:
Disabled - To disable daylight saving time.
Enabled - To disable daylight saving time.
6. Click Apply.