Enabling or disabling gvrp on a port – Allied Telesis AT-S63 User Manual
Page 362
Chapter 22: GARP VLAN Registration Protocol
362
Section V: Virtual LANs
Enabling or Disabling GVRP on a Port
To enable or disable GVRP on a port, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 38.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab displayed by
default, as shown in Figure 25 on page 94.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 146 on page 360.
4. In the GVRP Port Configuration section, click the ports that you want
to configure.
5. Click Modify.
The GVRP Port Configuration page is shown in Figure 147.
Figure 147. GVRP Port Configuration Page
6. Click Normal to have the port propagate GVRP information, or None
to prevent processing GVRP information and transmitting PDUs.
7. Click Apply to save the change, or Cancel to cancel.