Allied Telesis AT-S63 - Manual (Page 383)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 383
The Configure SNMPv3 Target Address Table menu is shown in
Figure 119 on page 393.
Note
To display a Group Name and its associated parameters from the
Configure SNMPv3 SecurityToGroup Table menu, type N to display
the Next Page and P to display the previous page.
3. To delete an SNMPv3 Target Address Table entry, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Address Name:
4. Enter a Target Address Name.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
5. Enter Y to delete the SNMPv3 Target Address Table entry or N to save
the entry.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 Target
Address Table
Entry
This section describes how to modify parameters in an SNMPv3 Target
Address Table entry. See the following procedures:
❑ ”Modifying a Target IP Address” on page 383
❑ ”Modifying the Target Address UDP Port” on page 385
❑ ”Modifying the Target Address Timeout” on page 386
❑ ”Modifying the Target Address Retries” on page 387
❑ ”Modifying the Target Address Tag List” on page 388
❑ ”Modifying the Target Parameters Field” on page 389
❑ ”Modifying the Storage Type” on page 390
Note
You cannot modify the Target Address Name parameter.
Modifying a Target IP Address
To modify the target IP address in an SNMPv3 Target Address Table
entry, perform the following procedure.