Allied Telesis AT-MC602 - Manual (Page 39)

AT-MC601, AT-MC602 Installation and User’s Guide (For Use with AT-MCR12 Only)
39
The parameters on the Configuration screen are described below.
Upstream/Downstream
The upstream and downstream data transfer rate.
❑ Actual (Mbps)
Displays the actual data transfer rate on the line. The software
automatically detects this speed.
❑ Min (Mbps)
Allows you to adapt the data transfer rate by setting a minimum
speed.
❑ Max (Mbps)
Allows you to adapt the data transfer rate by setting a maximum
speed.
The maximum and minimum speeds in Mbps available in the pull-down
menus are:
Status
This field will display “Select speed to set” until you have selected data
rates from the upstream and downstream pull-down menus and set the
rates by clicking the Apply button. Then reports on the status of the
attempt to configure the speeds selected from the upstream and
downstream pull-down menus will appear in this field. A successful
configuration attempt will cycle though the following status reports:
Looking for link status...
Checking signal/noise ratio
Loading a Configuration DS=1.41 US=2.81
(This report will keep repeating with progressively higher
upstream and downstream values until the set rate or the
highest possible rate has been achieved.)
Saving config on EEPROM - S Side
Saving config on EEPROM - P Side
Done
0.94
1.06
1.41
1.88
2.11
2.81
3.75
4.22
5.63
7.50
8.44
11.26
15.01
16.88 (upstream only)