Allied Telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT - Manual (Page 97)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
• Parameter 4
• Parameter 5
• QoS Class
• Status
Attempting to configure these parameters will result in the error message: "The error
occurred with 'Set' operation. Error: gen Error."
Virtual Path Link (VPL)
Displays configuration and state information for a bi-directional Virtual Path Link.
Note - The Virtual Path Link (VPL) sub-menu option does not display the correct
parameters. Instead, it displays the sub-menu option name as a parameter with a value of
'noSuchName'.
Virtual Channel Link (VCL)
Displays configuration and state information for a bi-directional Virtual Channel Link.
Note - AT-AR240E : The current firmware version does not allow the following parameters
to be configured:
• Administrative Status
• Receive Traffic Descriptor Index
• Transmit Traffic Descriptor Index
• AAL Type
• AAL5 CPCS Transmit SDU Size
• AAL5 CPCS Receive SDU Size
• AAL5 Encapsulation Type
Attempting to configure these parameters will result in the error message: "The error
occurred with 'Set' operation. Error: gen Error".
Note - AT-AR240E: The Port Number parameter and the Virtual Channel Link (VCL)
parameters are not relevant and should be ignored.
Note - AT-AR240E : The current firmware version does not allow the Status parameters to
be configured. Attempting to configure them will result in the error message: "The error
occurred with 'Set' operation. Error: bad value." or "The error occurred with 'Set' operation.
Error: gen Error".
Note - AT-AR250E/AT-AR255E : The Virtual Channel Link (VCL) sub-menu option does
not display the correct parameters. Instead, it displays the sub-menu option name as a
parameter with a value of 'noSuchName'.
PN 613-50665 Rev A Page 97 of 257