Allied Telesis AT-VIEW PLUS 2.3 DEVICE MANAGEMENT - Manual (Page 25)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
PN 613-50507-00 Rev C Page 25 of 224
Note - Under the Sun Solaris platform, the AT-View Plus Device Manager application may
terminate abnormally if multiple ports have been selected and each dialog box with the
message "May I set 'atiswitchPortState.n' to down" is clicked one after the other.
Port Mirroring
Displays port mirroring parameters and allows configuration of port mirroring state, source,
and destination.
Note - Valid MIB Set values for the Mirroring Destination Port parameter should range from
0 to 24. However, the current firmware version allows the user to enter values up to 65535.
Attempting to enter values greater than 65535 will cause the new value to be converted to its
equivalent wrap-around value; i.e., 65536 will become 0, 65537 will become 1, and so on.
Note - Valid MIB Set values for the Port Mirroring Status parameter are 'receive', 'transmit',
and 'both'. However, the current firmware version does not allow this parameter to be set to
'receive' and 'transmit'. Attempting to do so will result in the error message: "The error
occurred with 'Set' operation. Error: bad value".
Stacking Menu
From the Stacking menu, you can perform enhanced stacking from any AT-8000 Series master
switch.
Stacking Info
Displays information about the switch's mode. This is also the menu where you can perform
enhanced stacking.
Expansion Module Notes
• AT-View Plus Device Manager cannot distinguish between the AT-A45/xx, AT-A47, and
AT-STACKM expansion modules. All are displayed with the same GIF image.
• When both the AT-A45 and AT-A46 expansion modules are present on a device, the AT-
A45 port image may show up as green and its Port Speed parameter may reflect the value "1
Gbps" even if there is no connection established on the port. To reflect the correct port image
color and port speed, restart the device. This applies to the following devices:
ƒ AT-8016F/xx
ƒ AT-8024M
ƒ AT-8088/xx
• Connection cannot be established on the AT-A46 expansion module port if the Port Speed
and Mode parameter is set to "auto 1Gbps".